Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
VBST Configuration
This chapter describes how to configure the VLAN-based Spanning Tree (VBST). VBST is a spanning tree protocol developed by Huawei. It constructs a spanning tree in each VLAN to load balance traffic from different VLANs, improving link use efficiency.
- Introduction to VBST
- Principles
- Applicable Scenario
- Configuration Task Summary
- Licensing Requirements
and Limitations for VBST
- Default Configuration
- Configuring Basic VBST Functions
After you configure the operation mode of VBST and start VBST, VBST calculates the spanning tree and prunes a network into a tree network to eliminate loops. Network planners can also set parameters such as the switch priority, port path cost, and port priority to adjust the spanning tree calculation result. - Setting VBST Parameters That Affect VBST Convergence
After basic VBST functions are configured, VBST implements fast convergence using default parameters. To achieve better convergence, set parameters that affect VBST convergence. - Configuring Protection Functions of VBST
VBST provides BPDU protection, TC protection, root protection, and loop protection, and you can configure one or more protection functions as needed. - Setting Parameters for Interworking Between a Huawei Datacom Device and a Non-Huawei Device
To implement interworking between a Huawei datacom device and a non-Huawei device, configure the fast transition mode according to the Proposal/Agreement mechanism of the non-Huawei device. - Maintaining VBST
- Configuration Examples