Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring ERPS Protection Switching
Context
To ensure that ERPS rings function normally when a node or link fails, configure revertive/non-revertive switching, port blocking mode, and timers.
Procedure
- Run:
system-viewThe system view is displayed.
- Run:
erps ring ring-id
The ERPS ring view is displayed.
- Run:
revertive { enable | disable }
The protection switching mode is specified.
By default, ERPS rings use revertive switching.
- Run:
quitReturn to the system view.
- Run:
interface interface-type interface-number
The interface view is displayed.
- Run:
erps ring ring-id protect-switch { force | manual }
A port blocking mode is specified.
The ERPS ring specified by ring ring-id must be the one to which the port belongs.
To delete the specified port blocking mode, run the clear command in the ERPS ring view.
- Run:
quitReturn to the system view.