No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R010C00 Configuration Guide - Interface Management

This document describes the principles and configurations of interfaces and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the IFG

Configuring the IFG


An interframe gap (IFG) is used to separate two data packets, as shown in Figure 2-7. You can configure the IFG to change the packet forwarding rate on an interface, thereby adjusting the data forwarding capacity of the interface.

The packet forwarding rate, also called throughput, refers to the data forwarding capability on an interface and is measured in packet per second (pps). The packet forwarding rate is calculated based on the number of 64-byte data packets transmitted in a period. The lengths of preamble and IFG affect the packet forwarding rate.

The default IFG is the maximum value of 12 bytes and is recommended. If you set the IFG to a small value, the device will not have enough time to receive the next frame after receiving one data frame. The packets then cannot be processed in real time, which results in packet loss.

Figure 2-7  IFG


On the S12700, only the ET1D2L02QSC0 and ET1D2L08QSC0 interface cards support the IFG configuration.


  1. Run:


    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. Run:

    ifg ifg-value

    The IFG is configured.

    The default IFG is 12 bytes.

Updated: 2019-04-18

Document ID: EDOC1000142085

Views: 20755

Downloads: 69

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next