No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - QoS

This document describes the configurations of QoS functions, including MQC, priority mapping, traffic policing, traffic shaping, interface-based rate limiting, congestion avoidance, congestion management, packet filtering, redirection, traffic statistics, ACL-based simplified traffic policy, and HQoS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring an Interface Priority

(Optional) Configuring an Interface Priority

Context

An interface's priority is used in the following scenarios:
  • If the interface receives untagged packets, the device provides differentiated services for the packets based on the interface priority.

  • If the priority mapping function is disabled on the interface using the trust upstream none command, packets received on the interface can only be forwarded through priority mapping. In this case, the device provides differentiated services for the packets based on the interface priority.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. Run:

    port priority priority-value

    The interface priority is set.

    The default interface priority is 0.

    NOTE:

    An interface switched to Layer 3 mode using the undo portswitch command uses priority 0 and cannot have a priority configured for it.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142089

Views: 45123

Downloads: 87

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next