No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - QoS

This document describes the configurations of QoS functions, including MQC, priority mapping, traffic policing, traffic shaping, interface-based rate limiting, congestion avoidance, congestion management, packet filtering, redirection, traffic statistics, ACL-based simplified traffic policy, and HQoS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Data Buffer

(Optional) Configuring the Data Buffer

Context

The data buffer caches packets to be sent from an interface to prevent packet loss upon traffic bursts. When the data buffer is full, the device does not cache packets and directly discards packets not entering the buffer. You can adjust the buffering capacity of interface queues to improve the forwarding performance.

NOTE:

In enhanced mode, the qos burst-mode (interface view) and qos burst-mode (system view) commands cannot be used together, and the two commands cannot be used with the qos queue length command.

Procedure

  • Configure a burst traffic buffering mode on an interface.
    1. Run:

      system-view

      The system view is displayed.

    2. Run:

      interface interface-type interface-number

      The interface view is displayed.

    3. Run:

      qos burst-mode { enhanced | extreme }

      A burst traffic buffering mode is configured on the interface.

      The enhanced mode is recommended because the extreme mode may affect forwarding on other interfaces.

      NOTE:

      SA and X1E series cards do not support this command.

  • Configure a burst traffic buffering mode on a card.
    1. Run:

      system-view

      The system view is displayed.

    2. Run:

      qos burst-mode { enhanced | extreme } slot slot-id

      A burst traffic buffering mode is configured on a card.

      The enhanced mode is recommended because the extreme mode may affect forwarding on other interfaces.

      NOTE:

      SA and X1E series cards do not support this command.

  • Configure queue lengths on an interface.
    1. Run:

      system-view

      The system view is displayed.

    2. Run:

      interface interface-type interface-number

      The interface view is displayed.

    3. Run:

      shutdown

      The interface is shut down.

    4. Run:

      qos queue queue-index length length-value

      The length of a queue is set.

      NOTE:

      The ET1D2L02QSC0, ET1D2L08QSC0, ET1D2X48SEC0, ET1D2C02FEE0, SC series, and X series cards do not support this command.

    5. Run:

      undo shutdown

      The interface is restarted.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142089

Views: 42537

Downloads: 87

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next