No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R010C00 Configuration Guide - QoS

This document describes the configurations of QoS functions, including MQC, priority mapping, traffic policing, traffic shaping, interface-based rate limiting, congestion avoidance, congestion management, packet filtering, redirection, traffic statistics, ACL-based simplified traffic policy, and HQoS.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a WRED Drop Profile

Configuring a WRED Drop Profile


A WRED drop profile defines the upper drop threshold, lower drop threshold, and drop probability for different colored packets. WRED randomly discards packets based on drop parameters to prevent global TCP synchronization, and defines different drop policies based on packet colors. WRED discards packets based on packet priorities. Packets with higher priorities have a low probability of being discarded. For more information about packet colors, see Configuring Priority Mapping.


  1. Run:


    The system view is displayed.

  2. Run:

    drop-profile drop-profile-name

    A WRED drop profile is created and the drop profile view is displayed.

    By default, the WRED drop profile default exists. The default WRED drop profile exists, which can be modified but not deleted.

  3. Run:

    color { green | non-tcp | red | yellow } low-limit low-limit-percentage high-limit high-limit-percentage discard-percentage discard-percentage

    WRED parameters are set. low-limit specifies the lower threshold, high-limit specifies the upper threshold, and discard-percentage specifies the maximum drop probability.

    By default, low-limit, high-limit, and discard-percentage of a WRED drop profile are all set to 100.


    The WRED algorithm for non-TCP packets cannot be used on ET1D2X48SEC0, SC series, SA series, and EE series cards.

    On SA series cards, the WRED algorithm can be used only for green or red packets.

  4. (Optional) Run:

    queue-depth queue-depth-value

    The length of the port queue is set.


    Only X series cards support this command.

Updated: 2019-08-21

Document ID: EDOC1000142089

Views: 43211

Downloads: 87

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next