No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - QoS

This document describes the configurations of QoS functions, including MQC, priority mapping, traffic policing, traffic shaping, interface-based rate limiting, congestion avoidance, congestion management, packet filtering, redirection, traffic statistics, ACL-based simplified traffic policy, and HQoS.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Traffic Policy

Configuring a Traffic Policy

Pre-configuration Tasks

Before configuring a traffic policy, complete the following tasks:

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    traffic policy policy-name [ match-order { auto | config } ]

    A traffic policy is created and the traffic policy view is displayed, or the view of an existing traffic policy is displayed.

    If no matching order is specified when you create a traffic policy, the default matching order is config.

    After a traffic policy is applied, you cannot use the traffic policy command to modify the matching order of traffic classifiers in the traffic policy. To modify the matching order, delete the traffic policy, and re-create a traffic policy and specify the matching order.

    When creating a traffic policy, you can specify the matching order of matching rules in the traffic policy. The matching order can be either automatic order or configuration order:
    • If automatic order is used, traffic classifiers are matched based on the priorities of their types. The traffic classifiers based on the following information are in descending order of priority: Layer 2 and IPv4 Layer 3 information, advanced ACL6 information, basic ACL6 information, Layer 2 information, IPv4 Layer 3 information, and user-defined ACL information. The traffic classifier with the highest priority is matched first. If data traffic matches multiple traffic classifiers, and the traffic behaviors conflict with each other, the traffic behavior corresponding to the highest priority rule takes effect.
    • If configuration order is used, traffic classifiers are matched based on their priorities. The traffic classifier with the highest priority is matched first. A smaller priority value indicates a higher priority of a traffic classifier. If precedence-value is not specified, the system allocates a priority to the traffic classifier. The allocated priority value is [(max-precedence + 5) / 5] x 5, where max-precedence specifies the maximum priority of a traffic classifier. For details about the priority of a traffic classifier, refer to the traffic classifier command.
  3. Run:

    classifier classifier-name behavior behavior-name

    A traffic behavior is bound to a traffic classifier in a traffic policy.

  4. Run:

    quit

    Exit from the traffic policy view.

  5. Run:

    quit

    Exit from the system view.

Translation
Download
Updated: 2019-12-28

Document ID: EDOC1000142089

Views: 49612

Downloads: 88

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next