No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - Reliability

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a VRRP6 Group and Binding the VRRP6 Group to an mVRRP6 Group

Configuring a VRRP6 Group and Binding the VRRP6 Group to an mVRRP6 Group

Context

You can bind VRRP6 groups to an mVRRP6 group so that mVRRP6 determines the status of the bound VRRP6 groups.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The view of the interface where a VRRP6 group is configured is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run:

    vrrp6 vrid virtual-router-id virtual-ip virtual-ipv6-address [ link-local ]

    A VRRP6 group is created, and a virtual IPv6 address is assigned to the VRRP6 group.

    By default, no VRRP6 group is created.

    Because the mVRRP6 group determines the status of its member VRRP6 groups, you do not need to set priorities for the member VRRP6 groups.

  5. Run:

    vrrp6 vrid virtual-router-id1 track admin-vrrp6 interface interface-type interface-number vrid virtual-router-id2 unflowdown

    The VRRP6 group is bound to an mVRRP6 group.

    By default, no VRRP6 group is bound to an mVRRP6 group.

    After the binding is complete, the state machine of the bound VRRP6 group depends on the status of the mVRRP6 group. That is, the bound VRRP6 group inherits the status of the mVRRP6 group, deletes its VRRP6 Advertisement packet timeout timer, and stops sending or receiving VRRP6 Advertisement packets. A VRRP6 group can be bound to only one mVRRP6 group.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1000142090

Views: 82214

Downloads: 104

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next