No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - Reliability

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
When VRRP Packets Are Sent in a Super-VLAN, Why VRRP Heartbeat Packets Cannot Be Transmitted Normally Between VRRP Master and Backup Devices When the Link Between Them Does Not Allow the First Sub-VLAN of the Super-VLAN?

When VRRP Packets Are Sent in a Super-VLAN, Why VRRP Heartbeat Packets Cannot Be Transmitted Normally Between VRRP Master and Backup Devices When the Link Between Them Does Not Allow the First Sub-VLAN of the Super-VLAN?

By default, VRRP Advertisement packets of a super-VLAN are sent only to the sub-VLAN that has the smallest VLAN ID among all the sub-VLANs in Up state. You use the vrrp advertise send-mode command to cancel or configure the mode in which VRRP Advertisement packets of a super-VLAN are sent.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142090

Views: 102126

Downloads: 113

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next