No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - Reliability

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring VRRP6 Advertisement Packet Attributes

(Optional) Configuring VRRP6 Advertisement Packet Attributes

Context

VRRP6 Advertisement packets are used to advertise the master router's priority value and status to other VRRP6 routers in a VRRP6 group. Sending the VRRP6 Advertisement packets helps implement status transition and master election. VRRP6 packets have the following attributes:

  • VRRP6 TTL detection: A VRRP-enabled device checks the TTL in every received VRRP6 Advertisement packet and discards the packets if the TTLs are not 255. On a network with Huawei and non-Huawei devices, this function needs to be disabled to prevent packet loss.

  • Sending ND packets carrying only the minimal inner VLAN ID: A QinQ termination sub-interface sends ND packets with two tags and the inner tag is a range of VLAN IDs. To ensure that switches connected to users learn the correct MAC address of the VRRP group, the VRRP group on the QinQ termination sub-interface sends ND packets to all VLANs identified by inner VLAN IDs. This increases the burden on the VRRP-enabled device. To release the burden, the VRRP-enabled device can be configured to send ND packets carrying only the minimal inner VLAN ID.

Procedure

  • Disable VRRP6 TTL check.
    1. Run:

      system-view

      The system view is displayed.

    2. Run:

      interface interface-type interface-number

      The interface view is displayed.

    3. (Optional) On an Ethernet interface, run undo portswitch

      The interface is switched to Layer 3 mode.

      By default, an Ethernet interface works in Layer 2 mode.

    4. Run:

      vrrp6 un-check hop-limit

      The device is configured not to check the TTL value in VRRP6 Advertisement packets.

      By default, the system checks the TTL value in VRRP6 Advertisement packets.

    5. Run:

      quit

      The system view is displayed.

  • Configure the VRRP-enabled device to send ND packets carrying only the minimal inner VLAN ID.
    1. Run:

      interface interface-type interface-number .subinterface-number

      The view of an Ethernet sub-interface or Eth-Trunk sub-interface that is configured with QinQ VLAN tag termination is displayed.

    2. Run:

      vrrp6 nd send-mode simple

      The QinQ termination sub-interface in the Master state is configured to send ND packets carrying the outer VLAN ID and the minimal inner VLAN ID.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142090

Views: 95395

Downloads: 109

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next