No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - Reliability

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Association Between VRRP and BFD

Association Between VRRP and BFD

A VRRP group sends and receives VRRP Advertisement packets to determine the master and backup statuses, thereby implementing redundancy. If links connected to a VRRP group fail, VRRP Advertisement packets cannot be sent for negotiation. A backup will switch to the master after three times the duration of the interval (about 3s) at which point VRRP Advertisement packets are sent. During the switchover period, service traffic is still sent to the original master, causing user traffic loss.

BFD can rapidly detect connectivity of links on the network. Association between VRRP and BFD implements a fast switchover within 1 second. A BFD session is set up between the master and backup and is bound to a VRRP group. BFD detects faults of the VRRP group. When a fault occurs, BFD notifies the VRRP group of performing an active/standby switchover, greatly reducing the service interruption time.

A VRRP group can be associated with a static BFD session or a BFD session with automatically negotiated parameters.

There are two modes of association between VRRP and BFD. Table 3-3 describes the differences between the two modes.

Table 3-3  Two modes of association between VRRP and BFD

Association Mode

Usage Scenario

Impact

Device Setting

Common mode

The backup detects whether the master works properly. The BFD session is often used to monitor the status of the link between the master and backup.

The VRRP group adjusts its priority according to the BFD session status and determines whether to perform an active/standby switchover according to the adjusted priority.

The device configured with VRRP must support BFD.

Peer mode

The backup detects whether the master works properly. The BFD session is often used to monitor the status of the link between the master and backup.

When the peer BFD session status changes, the VRRP device's priority remains unchanged and the VRRP group status is reconfigured.

The device configured with VRRP must support BFD.

Figure 3-8  Association between VRRP and BFD

As shown in Figure 3-8, a VRRP group is configured between SwitchA and SwitchB. SwitchA is the master and SwitchB is the backup. User traffic is forwarded through SwitchA. SwitchA and SwitchB work in preemption mode, and immediate preemption is configured on SwitchB. BFD sessions are configured on SwitchA and SwitchB and association between VRRP and BFD is configured on SwitchB.

When a fault occurs in the VRRP group, BFD rapidly detects the fault and instructs SwitchB to increase the priority to a value higher than that of SwitchA. SwitchB immediately switches to the master and forwards user-side traffic, implementing a rapid active/standby switchover.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1000142090

Views: 83097

Downloads: 104

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next