No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - Reliability

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Delay Before a BFD Session Becomes Up

Setting the Delay Before a BFD Session Becomes Up

Context

In practice, some devices determine whether to switch traffic based on the BFD session status. Because the routing protocol becomes Up after the interface becomes Up, routes will be not found when services are switched back, causing traffic loss. Therefore, the interval between the time when the routing protocol becomes Up and the time when the interface becomes Up must be eliminated.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    bfd

    Global BFD is enabled and the BFD view is displayed.

  3. Run:

    delay-up time

    A delay before a BFD session is set.

    By default, the delay before a BFD session becomes Up is 0.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1000142090

Views: 83789

Downloads: 104

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next