No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - Reliability

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Enabling Revertive Switching

(Optional) Enabling Revertive Switching

Context

When the active link in a Smart Link group fails, traffic is automatically switched to the standby link. After the fault is rectified, the original active link remains blocked to ensure stable traffic transmission. To enable the original active link to transmit traffic, use either of the following methods:

  • Enable revertive switching in the Smart Link group. Service traffic will be switched to the original active link when the WTR timer expires.
  • Run the smart-link manual switch command to forcibly trigger link switching.
NOTE:
  • Service traffic can be switched between links in a Smart Link group only when both member interfaces are in Up state.

  • Configure revertive switching before enabling the Smart Link group. If the Smart Link group has been enabled, disable the Smart Link group before enabling revertive switching.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    smart-link group group-id

    The Smart Link group view is displayed.

  3. Run:

    restore enable

    Revertive switching is enabled for the Smart Link group.

    By default, revertive switching is disabled in a Smart Link group.

  4. Run:

    timer wtr wtr-time

    The WTR time is set.

    By default, the WTR time of a Smart Link group is 60 seconds.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142090

Views: 95164

Downloads: 109

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next