No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - Reliability

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Global TTL Value

Setting the Global TTL Value

Context

When devices running different versions interwork with each other, the TTL values and detection modes on both ends of the BFD session are different and BFD packets are discarded. You can set the global TTL value to enable the Huawei device to interwork with each other in different versions, with upgraded devices, and with non-Huawei devices.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    bfd

    BFD is enabled globally on the local node and the BFD view is displayed.

  3. Run:

    peer-ip peer-ip mask-length ttl { single-hop | multi-hop } ttl-value

    The TTL value of BFD control packets is set.

    The TTL value of BFD packets varies with the BFD session type. By default, for a static BFD session, the TTL value of a single-hop BFD packet is 255 and the TTL value of a multi-hop BFD packet is 254. For a dynamic BFD session, the TTL value of a single-hop BFD packet is 255 and the TTL value of a multi-hop BFD packet is 253.

    NOTE:
    • After the TTL value in multi-hop BFD packets is configured, you must configure the same peer IP address, mask length longer than the mask length for the TTL value in multi-hop BFD packets, and TTL value in single-hop BFD packets. This is because the TTL value in multi-hop BFD packets affects dynamic single-hop BFD sessions.

    • You must change the global TTL value on both ends of a BFD session in Up state. Otherwise, the BFD session cannot go Up again.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142090

Views: 95322

Downloads: 109

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next