No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R010C00 Configuration Guide - Reliability

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the Running Status of Ethernet CFM

Monitoring the Running Status of Ethernet CFM


To check the running status of Ethernet CFM during routine maintenance, run the following display commands in any view.


  • Run the display oam global configuration command to check the global configuration of Ethernet OAM.
  • Run the display cfm mep [ md md-name [ ma ma-name [ mep-id mep-id ] ] ] command to check information about a MEP.
  • Run the display cfm mip [ interface interface-type interface-number | level level ] command to check information about a MIP.
  • Run the display cfm remote-mep [ md md-name [ ma ma-name ] ] [ cfm-state { up | down | disable } ] command to check information about an RMEP.
Updated: 2019-08-21

Document ID: EDOC1000142090

Views: 94007

Downloads: 107

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next