No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - Reliability

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Local MAC Swap Loopback

Configuring Local MAC Swap Loopback

Pre-configuration Tasks

A local MAC swap loopback test checks Ethernet connectivity and network performance.

Before configuring local MAC swap loopback, complete the following tasks:

  • Create a VLAN and add the interface where you want to perform the remote MAC swap loopback test to the VLAN.

  • Configure QoS CAR if you want to test QoS on the network (see Traffic Policing, Traffic Shaping, and Interface-based Rate Limiting in the S12700 V200R010C00 Configuration Guide - QoS).

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142090

Views: 89338

Downloads: 107

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next