No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - WLAN-AC

This document describes native AC (hereinafter referred to as WLAN AC) configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling N+1 Backup

Enabling N+1 Backup

Context

After all N+1 backup configurations are complete, enable N+1 backup and then restart all APs to make the function take effect.

N+1 backup needs to be enabled on all ACs.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    wlan

    The WLAN view is displayed.

  3. Run:

    undo ac protect enable

    N+1 backup is enabled.

    By default, N+1 backup is enabled.

  4. (Optional) Run:

    ap-reset { all | ap-name ap-name | ap-mac ap-mac | ap-id ap-id | ap-group ap-group | ap-type { type type-name | type-id type-id } }

    All APs are restarted to make the N+1 backup function take effect.

    NOTE:

    If N+1 backup is enabled, running the undo ac protect enable command does not restart online APs. You need to run the ap-reset { all | ap-name ap-name | ap-mac ap-mac | ap-id ap-id | ap-group ap-group | ap-type { type type-name | type-id type-id } } command to restart the APs and make the N+1 backup function take effect. You can also manually restart the APs to make the N+1 backup function take effect.

    If the N+1 backup function is disabled, running the undo ac protect enable command restarts online APs. After the APs are restarted, the N+1 backup function starts to take effect.

    If an AP goes online after N+1 backup is enabled, you do not need to restart the AP.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142094

Views: 150656

Downloads: 128

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next