No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R010C00 Configuration Guide - WLAN-AC

This document describes native AC (hereinafter referred to as WLAN AC) configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking Connectivity Between an AP and a Network Device

Checking Connectivity Between an AP and a Network Device


When a network fault occurs, use an AP to ping other network devices to check the connectivity.


  1. Run:


    The system view is displayed.

  2. Run:


    The WLAN view is displayed.

  3. Run the ap-ping { ap-name ap-name | ap-id ap-id } [ -c count | -s packetsize | -m time | -t timeout ] * host command to ping a network device from an AP to check network connectivity between them.
Updated: 2019-08-21

Document ID: EDOC1000142094

Views: 137565

Downloads: 123

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next