No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R010C00 Configuration Guide - WLAN-AC

This document describes native AC (hereinafter referred to as WLAN AC) configuration procedures and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for IoT APs

Licensing Requirements and Limitations for IoT APs

Involved Network Elements

  • APs mentioned in this document are Huawei AP products. You are advised to use Huawei APs to connect to the AC.
  • You can run the display ap-type all command to check the default AP types supported by the device.

Product Software Version

AP Software Version










Licensing Requirements

When an X series card is used as a WLAN AC, the number of online APs supported by the X series card is controlled by licenses. The X series card supports a maximum of 16 online APs. To increase the number of online APs supported by the card, apply for and purchase a license from the agent.
  • AP resource license-16AP for WLAN access controller
  • AP resource license-64AP for WLAN access controller
  • AP resource license-128AP for WLAN access controller
  • AP resource license-512AP for WLAN access controller

For details about how to apply for a license, see S Series Switch License Use Guide.

Version Requirements

Table 20-1  Products and minimum version supporting the WLAN service
Product Minimum Version Required
S12704/S12708/S12712 V200R009



Feature Limitations

  • Currently, only the AP4050DN-E supports IoT cards.

  • Third-party IoT cards must comply with Huawei's software and hardware interface standards.

  • A high volume of IoT service traffic may cause co-channel interference to Wi-Fi services.

Updated: 2019-12-31

Document ID: EDOC1000142094

Views: 187645

Downloads: 135

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next