No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - WLAN-AC

This document describes native AC (hereinafter referred to as WLAN AC) configuration procedures and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Management VLAN on an AP

Configuring a Management VLAN on an AP

Context

In practice, the PVID of an AP wired interface is usually set to the management VLAN ID. For details, see Configuration Precautions for WLAN. When management packets from the AP or data packets forwarded in tunnel mode reach the access device through the CAPWAP tunnel, the access device tags the packets with the PVID.

If the PVID of the access device has been used for other purposes (for example, as the default VLAN ID of wired users), the PVID cannot be configured as the management VLAN ID on the access device interface. In this case, configure CAPWAP packets sent from an AP wired interface to carry the management VLAN tag. The AP then adds the management VLAN ID to the CAPWAP packets sent to the AC. You only need to configure the access device to allow the packets carrying the management VLAN ID to pass.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    wlan

    The WLAN view is displayed.

  3. Run:

    ap-system-profile name profile-name

    An AP system profile is created, and the AP system profile view is displayed.

    By default, the system provides the AP system profile default.

  4. Run:

    management-vlan vlan-id
    CAPWAP packets sent from the AP wired interface are configured to carry a management VLAN tag.

    By default, CAPWAP packets sent from an AP wired interface do not carry a management VLAN tag.

    NOTE:

    On a Mesh network, ensure that CAPWAP packets sent from all APs carry the same management VLAN. Otherwise, MPs cannot go online.

    The configuration takes effect only after the AP is restarted.

  5. Run:

    quit

    Return to the WLAN view.

  6. Bind an AP system profile to an AP group or AP.

    • Binding an AP system profile to an AP group.
      1. Run the ap-group name group-name command to enter the AP group view.
      2. Run the ap-system-profile profile-name command to bind the AP system profile to the AP group.

        By default, the AP system profile default is bound to an AP group.

    • Binding an AP system profile to an AP.
      1. Run the ap-id ap-id, ap-mac ap-mac, or ap-name ap-name command to enter the AP view.
      2. Run the ap-system-profile profile-name command to bind the AP system profile to the AP.

        By default, no AP system profile is bound to an AP.

  7. Run:

    quit

    Return to the WLAN view.

  8. Run:

    commit { all | ap-name ap-name | ap-id { ap-id1 [ to ap-id2 ] } &<1-10> }

    Configurations are delivered to APs.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1000142094

Views: 120635

Downloads: 119

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next