No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - WLAN-AC

This document describes native AC (hereinafter referred to as WLAN AC) configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Traffic Limit

Configuring Traffic Limit

Context

Traffic limit configuration in a traffic profile can reduce unnecessary packet forwarding and improve air interface performance.

Pre-configuration Tasks

Before configuring traffic limit, perform the task of WLAN Service Configuration.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    wlan

    The WLAN view is displayed.

  3. Run:

    traffic-profile name profile-name

    A traffic profile is created, and the traffic profile view is displayed.

  4. Run the following commands as required:

    • Configure the maximum volume of broadcast traffic allowed in the traffic profile.
      1. Run the traffic-optimize broadcast-suppression packets packets-rate command to configure the maximum volume of broadcast traffic allowed in the traffic profile.

        By default, broadcast packets are not suppressed on a traffic profile.

    • Configure the maximum volume of multicast traffic allowed in the traffic profile.
      1. Run the traffic-optimize multicast-suppression packets packets-rate command to configure the maximum volume of multicast traffic allowed in the traffic profile.

        By default, multicast packets are not suppressed in a traffic profile.

    • Configure the maximum volume of unknown unicast traffic allowed in the traffic profile.
      1. Run the traffic-optimize unicast-suppression packets packets-rate command to configure the maximum volume of unknown unicast traffic allowed in the traffic profile.

        By default, unknown unicast packets are not suppressed in a traffic profile.

    • Forbid air interfaces to forward packets to bridging STAs.
      1. Run the traffic-optimize sta-bridge-forward disable command to forbid air interfaces to forward packets to bridging STAs.

        By default, an air interface is allowed to forward packets to bridging terminals.

  5. Run:

    quit

    Return to the WLAN view.

  6. Run:

    vap-profile name profile-name

    The VAP profile view is displayed.

  7. Run:

    traffic-profile profile-name

    The traffic profile is bound to the VAP profile.

    By default, the traffic profile default is bound to a VAP profile.

  8. Run:

    quit

    Return to the WLAN view.

  9. Run:

    commit { all | ap-name ap-name | ap-id { ap-id1 [ to ap-id2 ] } &<1-10> }

    Configurations are delivered to APs.

Verifying the Configuration

  • Run the display traffic-profile { all | name profile-name } command to check the traffic limit configuration in a traffic profile.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1000142094

Views: 121794

Downloads: 120

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next