No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - WLAN-AC

This document describes native AC (hereinafter referred to as WLAN AC) configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
STP Scenarios Supported by a Mesh Network

STP Scenarios Supported by a Mesh Network

NOTE:
  • Only when wired interfaces of the preceding APs are not bound to an Eth-trunk interface, an AC can deliver STP configurations to the APs.

A Mesh network supports only transparent transmission of Spanning Tree Protocol (STP) packets. An STP-enabled AP does not forward STP packets to the wireless side. STP takes effect only on the AP's wired side.

When deploying a Mesh network, avoid network loops. In Mesh networking, STP applies only to scenarios where the Mesh network forms a single loop with the wired network. Table 15-1 describes STP scenarios supported by a Mesh network.
Table 15-1  STP scenarios supported by a Mesh network
Scenario Description

Mesh links form a single loop with wired links. STP is enabled on non-AP network elements (NEs) on the loop but not enabled on NEs connected to the Mesh network that are not involved in the loop. In this case, STP takes effect and breaks the loop.

As shown in the figure, the SwitchA forms a single loop with Mesh links. To break the loop, enable STP on the SwitchA and ensure that STP is not enabled on GE0/0/1 connecting the SwitchB to the MPP.

The Mesh network connects to an AP with dual network ports. A loop exists on the AP's wired-side interfaces and the wired-side interfaces are not bound to an Eth-trunk interface. To prevent transparent forwarding of STA packets to the wireless side, enable STP on the AP.

In the figure, the AC, SwitchA, SwitchB, and MPP form a loop (loop 1), and SwitchC, SwitchD, and MP3 form a loop (loop 2). If STP packets can be transparently transmitted over Mesh links, STP on loop 1 incorrectly includes SwitchC and SwitchD on loop 2 into its calculation.

To prevent calculation errors, enable STP on the MPP and MP3 so that STP packets from loop 1 and loop 2 will not be transparently forwarded to the wireless side. The MPP implements STP calculation of loop 1 and blocks wired-side interfaces based on the calculation results. MP3 implements STP calculation of loop 2 and blocks wired-side interfaces based on the calculation results.

NOTE:
Mesh networks support Mesh link redundancy. To prevent loops, use Mesh routing to decide on the forwarding path.
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142094

Views: 137432

Downloads: 123

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next