No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R010C00 Configuration Guide - WLAN-AC

This document describes native AC (hereinafter referred to as WLAN AC) configuration procedures and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Air Scan Profile

Air Scan Profile

Overview

The air scan profile is used for radio calibration and Wireless Intrusion Detection System (WIDS) data analysis. An AP periodically scans surrounding radio signals and reports the collected information to an AC or server.

  • Radio calibration

    An authorized AP scans surrounding radio signals, collects information about surrounding authorized APs, rogue APs, and non-Wi-Fi devices, and reports the information to an AC.

  • Spectrum analysis

    An AP detects different types of interference resources on wireless networks, and displays the information to users. Users can then use the information to locate these interference sources. This function improves user experience.

  • WLAN device location

    An AP collects radio signals, and reports the location information to the positioning server. Alternatively, the AP can send the location information to the AC, which filters the information and sends the filtered information to the positioning server. An AP can collect radio signals in either of the two modes:
    • The AP collects Received Signal Strength Indicator (RSSI) information of WLAN terminals and rogue APs and reports the information to the positioning server. The information is then used to locate WLAN terminals or rogue APs
    • An AP scans spectrums and reports fast Fourier transform (FFT) results of radio signals to an AC. The information is then used to identify non-Wi-Fi interference sources.
  • WIDS data analysis

    A monitor AP scans channels to monitor information about neighboring wireless devices, collects information about neighboring wireless devices by listens on WLAN packets sent from neighboring wireless devices, and periodically reports collected information to an AC. The AC then uses the information to determine rogue devices.

The air scan profile takes effect only after it is referenced by the radio profile.

CLI-based Procedure

Translation
Download
Updated: 2019-12-31

Document ID: EDOC1000142094

Views: 188031

Downloads: 138

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next