No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei SAN Storage Host Connectivity Guide for Windows

HUAWEI SAN Storage Host Connectivity Guide for Windows Servers
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Storage System Configuration

Storage System Configuration

This section details how to add initiators to hosts on the storage system. For other storage configurations, see the Basic Storage Service Configuration Guide corresponding to your storage system.

  1. Log in to the storage system on a web browser.

    After you have configured the zones on the switch, log in to DeviceManager of the storage system and choose Provisioning > Host > Initiator. On the page that is displayed, select FC from the Initiator Type drop-down list. Check whether the host initiators have been discovered.

    As shown in Figure 5-10, the host initiators have been discovered and are online.

    Figure 5-10 Viewing initiators

  2. Click the Host tab, select the host that was created on the storage system, and click Add Initiator.

    Figure 5-11 Add Initiator dialog box

  3. Select FC from the Initiator Type drop-down list and find the host initiators' WWNs.

    Figure 5-12 Selecting initiators

  4. Select the host initiators and add them to Selected Initiators.

    Figure 5-13 Adding initiators

  5. Verify that the initiators have been added to the host correctly.

    Figure 5-14 Verifying the configuration

    As shown in Figure 5-14, the initiators have been added to the host successfully. The initiator properties depend on the operating system and multipathing software used by the hosts. For details, see storage configurations in Configuring Multipathing.

Download
Updated: 2019-08-22

Document ID: EDOC1000150159

Views: 77086

Downloads: 3475

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next