No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer Pro E9000 Server iBMC (V250 to V259) User Guide 19

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the SNMP Trap IP Address (trap -d address)

Setting the SNMP Trap IP Address (trap -d address)

Function

The trap -d address command is used to set the SNMP trap IP address.

Format

ipmcset -t trap -d address -v <destination> <ipaddr>

Parameters

Parameter Description Value
destination

Identifies an SNMP trap destination.

1 to 4
ipaddr Specifies the IP address for receiving SNMP trap messages. It can be an IPv4 address (in xxx.xxx.xxx.xxx format), an IPv6 address (in xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx format), or empty (in ""format).

Usage Guidelines

If ipaddr is empty, this command is used to clear the IP address.

The switch module does not support the command.

Example

# Set the IP address for receiving SNMP trap messages to 10.10.10.10.

iBMC:/->ipmcset -t trap -d address -v 1 10.10.10.10
Set trap dest1 address successfully.

# Clear the IP address of SNMP trap destination 1.

iBMC:/->ipmcset -t trap -d address -v 1 ""
Set trap dest1 address successfully.
Translation
Download
Updated: 2019-08-01

Document ID: EDOC1000157052

Views: 133399

Downloads: 259

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next