No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


FusionServer Pro E9000 Server iBMC (V250 to V259) User Guide 20

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the iBMC Network Port State (ethlink)

Setting the iBMC Network Port State (ethlink)


The maintenance -d ethlink command is used to set the state of the iBMC network port.


ipmcset -t maintenance -d ethlink -v <ethname> <action>


Parameter Description Value
ethname Specifies the iBMC network port to be set.
  • eth0
  • eth1
  • eth2
  • eth3

The number of iBMC network ports varies with the server model.

action Specifies the network port state.
  • enable
  • disable

Usage Guidelines

The switch module does not support the command.


# Enable iBMC network port eth2.

iBMC:/->ipmcset -t maintenance -d ethlink -v eth2 enable
WARNING: This operation will enable eth2.
Do you want to continue?[Y/N]:y
Enable eth2 successfully.
Updated: 2019-11-19

Document ID: EDOC1000157052

Views: 153346

Downloads: 287

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next