No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


FusionServer Pro E9000 Server iBMC (V250 to V259) User Guide 20

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to a Server Using the Independent Remote Console (macOS)

Logging In to a Server Using the Independent Remote Console (macOS)


Use the independent remote console to remotely access a server from a client running macOS.



  • The client (for example, a PC) is connected to the iBMC management network port of the server to be accessed.

  • The ipmitool later than 1.8.14 has been installed.


  • iBMC management network port IP address and port number
  • User name and password for logging in to the iBMC


You have downloaded the independent remote console software package to the client (PC) and decompressed it.


  1. Configure an IP address for the client (PC) to enable communication between the client and the iBMC. That is, the IP address configured and the iBMC management network port IP address must be in the same network segment.
  2. Open the console and specify the folder in which the IRC is stored as the working folder.
  3. Run the chmod 777 command to set the permission for the independent remote console.
  4. Run ./ to start the independent remote console.

    A dialog box similar to the one shown in Figure 7-8 is displayed.

    Figure 7-8 Login interface

  5. Enter the network address, user name, and password.

    The network address can be in any of the following formats:

    • iBMC [IPv6 address]:Port number or iBMC IPv4 address:Port number

      For example, [fc00::64]:444 or

    • iBMC domain name address:Port number
    • The iBMC versions earlier than V228 only support logins of local users. The iBMC V228 and later versions support logins of local and LDAP domain users.
    • For the versions earlier than iBMC V228, Port number indicates the RMCP+ service port number. For iBMC V228 and later versions, Port number indicates the HTTPS service port number.
    • The IPv6 address must be included in square brackets ([ ]), for example, [fc00::64]:444. Do not include the IPv4 address, for example,
    • If the default port number is used, you do not need to enter the port number.

  6. Select the login mode, and click Connect.

    • Shared Mode: allows two users to access and manage a server at the same time. The two users can see each other's operations.
    • Private Mode: allows only one user to access and manage a server.

    Information shown in Figure 7-9 is displayed.

    Figure 7-9 Security warning

    If no CA certificate is installed, click Import CA to import a CA certificate (*.cer, *.crt, or *.pem). After the CA certificate is imported, the security risk dialog box will no longer be displayed.

  7. Click Yes to open the remote console.

    The Remote Virtual Console of the server is displayed, as shown in Figure 7-10.

    Figure 7-10 Remote Virtual Console

Updated: 2019-11-19

Document ID: EDOC1000157052

Views: 153354

Downloads: 287

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next