ALM-0x02000027 Hard Disk Status Abnormal (Disk, Minor Alarm)
Description
Alarm message:
The [arg1] disk arg2 state is abnormal (SN: arg3, BN: arg4).
From iBMC V316, the CPU and disk alarms will also include the SN and BOM code and the mainboard and memory alarms will also include the BOM code.
This alarm is generated when an abnormal hard disk status is detected.
Alarm object: disk
This alarm also applies to SATADOM and M.2 disks.
Parameters
| Name | Meaning |
|---|---|
arg1 |
Location of the hard disk. For example, FM or CMn. |
arg2 |
Slot number of the hard disk. |
arg3 |
Disk serial number. |
arg4 |
BOM code. |
Possible Causes
- Improper operation was performed on the hard disk or RAID controller card.
- The hard disk is faulty.
Procedure
- Check for and clear the drive fault alarm.
- Change the drive firmware status to UNCONFIGURED GOOD or OFFLINE. Then, check whether the alarm is cleared.
To check the drive status, log in to the iBMC WebUI, choose , select the Configure tab, and change the hard disk firmware status.
- Replace the drive. Then, check whether the alarm is cleared.
For details about how to replace the drive, see the user guide of the server you use.
After replacing the drive, restore the drive data. For details, see "Drive Faults" in the user guide of the RAID controller card you use.
If yes, no further action is required.
If no, go to 4.
- Contact technical support engineer.
