Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ALM-0x10000065 Failed to Read System 5 V Voltage (Mainboard, Minor Alarm)
Description
Alarm message:
Failed to obtain the voltage at 5 V detection point on the mainboard (BN: arg1).
From iBMC V316, the CPU and disk alarms will also include the SN and BOM code and the mainboard and memory alarms will also include the BOM code.
This alarm is generated when the system failed to obtain the voltage at 5 V detection point.
Alarm object: mainboard
Impact on the System
The voltage cannot be monitored. No alarm will be reported when the voltage is not in the normal range.
Procedure
- Restart the iBMC. Then, check whether the alarm is cleared.
If yes, no further action is required.
If no, go to 2.
- Remove and reinstall the power cable or board. Then, check whether the alarm is cleared.
If yes, no further action is required.
If no, go to 3.
- Replace the mainboard. Then, check whether the alarm is cleared.
If yes, no further action is required.
If no, go to 4.
- Contact technical support engineer.
