Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Replacing an LCD
Prerequisites
- An LCD needs to be replaced.
- A spare LCD with the correct software version is available. If the LCD software is incorrect, upgrade the software by following the instructions in the ACC VxxxRxxxCxxxSPCxxx Software Upgrade Guide.
- Tool: Phillips screwdriver
Procedure
- Tap Shutdown on the ACC home screen.
Exercise caution because the NetCol5000-A is still energized when it is being shut down on the LCD.
- Open the front door and disconnect cables.Figure 6-52 Disconnecting cables
- Hold the LCD screen from the front, remove the four screws from the screen using a Phillips screwdriver, and then remove the LCD screen, as shown in Figure 6-53.
- Secure the spare LCD screen to the original position on the front door using a Phillips screwdriver.Figure 6-54 Installing an LCD
- Connect the cables to the LCD and close the front door.Figure 6-55 Connecting cables
- Power on the device and tap Start on the home screen. Ensure that the smart cooling product is running properly without any alarms.
