Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Export Data?
Context
With the one-click mode, you can export active alarms, historical alarms, run logs, and so on.
You are advised to use the FAT32 USB flash drive with a capacity no greater than 64 GB. Format the non-FAT32 USB flash drives into FAT32 ones before using them.
Before using a USB flash drive, ensure that its data has been scanned by antivirus software and is secure.
- Before exporting active alarms, historical alarms, logs, and configurations, ensure that the USB flash drive has been successfully identified. The USB port is located on the side of the screen.
- If the USB flash drive has been successfully identified,
is displayed in the status bar.
- If the USB flash drive is not properly connected, the system will display No USB device found. during operations about the USB flash drive.
is displayed in the status bar.Procedure
- Tap to enter the Select Path screen, as shown in Figure 7-17.
- Tap the file where the user saves current data in the Select Path dialog box and tap Next. Then tap Yes in the displayed dialog box.
- After the data is successfully exported, Figure 7-18 is displayed. Click Finish.
- Click to remove the USB flash drive in safe mode.
