No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor 9000 V300R006C10 Parts Replacement 06

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Replacing a Power Module

Replacing a Power Module

This section explains how to replace a power module of the C72.

Impact on the System

During the replacement of a power module, system reliability is reduced.

Prerequisites

  • A replacement power module is ready.
  • The power module that you want to replace has been located.
  • The power cable has been disconnected from the power module that you want to replace.

Precaution

  • Do not touch the connectors of a power module and a power cable.
  • Use care when you remove and insert a disk module to avoid any damage to the appearance or connectors of the power module.
  • Remove only one power module at a time.
  • You are advised to replace a power module within the shortest time possible.

Tools and Materials

  • ESD wrist strap
  • ESD bag
  • Labels

Procedure

  1. Wear an ESD wrist strap.
  2. Press the latch on the power module and pull out the power module, as shown in Figure 7-11.

    Figure 7-11  Removing a power module

  3. Place the removed power module into an ESD bag.
  4. Take the replacement power module out of its ESD bag.
  5. Insert the replacement power module into the empty slot until it clicks into place, as shown in Figure 7-12.

    Figure 7-12  Installing a power module

  6. Connect the power cable and secure it to the power socket.
  7. Wait about two minutes and check the status of the activity indicator on the power module to determine whether the power module is successfully installed. Figure 7-13 shows the location of the status indicator.

    • If the indicator is steady green, the power module is successfully installed.
    • If the indicator is off, the newly installed power module is faulty, the slot that houses the power module is faulty, or the power module is incorrectly installed.
    Figure 7-13  Activity indicator of a power module

Follow-up Procedure

After replacing the power module, label it to facilitate subsequent operations.

Translation
Download
Updated: 2019-02-25

Document ID: EDOC1000162172

Views: 24809

Downloads: 28

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next