Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Scanning LUNs on a Host
To change the LUN mappings on the storage system, including but not limited to removing and adding a LUN, modifying the host LUN ID, and changing the port online, refer to How Can I Change LUN Mappings When Non-Huawei Multipathing Software Is Used?
After configuring an initiator, check its status.
- If its Status is Online, the FC connection is set up successfully.
- If its Status is Offline, run the cfgmgr -v command on host to scan hardware.
To enable the host to discover mapped LUNs, perform the following operations:
- Run the cfgmgr -v command.
bash-3.2# cfgmgr -v
- Run the lsdev -Cc disk command to view the information about disks identified by the operating system.
bash-3.2# lsdev -Cc disk hdisk0 Available 01-08-00 SAS Disk Drive hdisk1 Available 01-08-00 SAS Disk Drive hdisk2 Available 06-00-02 Huawei XSG1 FC Disk Drive bash-3.2#
In this example, hdisk2 is identified.