No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
abr-summary (OSPFv3 Area)

abr-summary (OSPFv3 Area)


The abr-summary command configures IPv6 route summarization on an ABR.

The undo abr-summary command cancels IPv6 route summarization on an ABR.

By default, IPv6 route summarization is not configured on an ABR.


abr-summary ipv6-address prefix-length [ cost cost | not-advertise ] *

undo abr-summary ipv6-address prefix-length


Parameter Description Value
ipv6-address Specifies the address range of IPv6 routes to be summarized. The value is a 32-digit hexadecimal number, in the format of X:X:X:X:X:X:X:X.
prefix-length Specifies the prefix length. The value is an integer ranging from 1 to 128.
cost cost Specifies the cost of a summarized route. By default, the cost of a summarized route is the maximum cost among those of routes that are summarized. The value is an integer ranging from 0 to 16777214.
not-advertise Indicates that the summarized IPv6 routes that match a specified IPv6 address prefix or prefix length are not advertised. -


OSPFv3 area view

Default Level

2: Configuration level

Usage Guidelines

This command is applicable only to the ABR for route aggregation of the current area. The ABR transmits only one summarized route to other areas.

An area can be configured with multiple summarized network segments. Thus OSPFv3 can summarize multiple network segments.


# Summarize two routes FC00:0:0:1::/64 and FC00:0:0:2::/64 of OSPFv3 area 1 into route FC00:0:0::/48 with the cost being 400, and advertise it to other areas.

<HUAWEI> system-view
[~HUAWEI] ospfv3 1
[*HUAWEI-ospfv3-1] area 1
[*HUAWEI-ospfv3-1-area-] abr-summary fc00:0:0:: 48 cost 400
Related Topics
Updated: 2019-03-21

Document ID: EDOC1000166501

Views: 94311

Downloads: 407

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next