No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Command Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ospfv3 suppress-flapping peer disable

ospfv3 suppress-flapping peer disable

Function

The ospfv3 suppress-flapping peer disable command disables OSPFv3 neighbor relationship flapping suppression from an interface.

The undo ospfv3 suppress-flapping peer disable command enables OSPFv3 neighbor relationship flapping suppression on an interface.

By default, OSPFv3 neighbor relationship flapping suppression is enabled on all interfaces.

Format

ospfv3 suppress-flapping peer disable [ instance instance-id ]

undo ospfv3 suppress-flapping peer disable [ instance instance-id ]

Parameters

Parameter Description Value
instance instance-id Specifies the ID of the instance to which an interface belongs.

The value is an integer ranging from 0 to 255. The default value is 0.

Views

Interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

By default, OSPFv3 neighbor relationship flapping suppression is enabled on all interfaces in the same OSPFv3 process. To disable the function from one of the interfaces, run the ospfv3 suppress-flapping peer disable command.

NOTE:
When an interface enters the flapping suppression state, all neighbor relationships on the interface enter the state accordingly.

Prerequisites

OSPFv3 neighbor relationship flapping suppression must have been enabled globally before you enable the function on an interface using the undo ospfv3 suppress-flapping peer disable command. By default, the function is enabled globally. If it is disabled, run the undo suppress-flapping peer disable command to enable it first.

Example

# Disable OSPFv3 neighbor relationship flapping suppression from 10GE1/0/1.

<HUAWEI> system-view
[~HUAWEI] ospfv3
[*HUAWEI-ospfv3-1] router-id 10.1.1.1
[*HUAWEI-ospfv3-1] quit
[*HUAWEI] interface 10ge 1/0/1
[*HUAWEI-10GE1/0/1] undo portswitch
[*HUAWEI-10GE1/0/1] ipv6 enable
[*HUAWEI-10GE1/0/1] ospfv3 suppress-flapping peer disable

# Disable OSPFv3 neighbor relationship flapping suppression from VLANIF100.

<HUAWEI> system-view
[~HUAWEI] ospfv3
[*HUAWEI-ospfv3-1] router-id 10.1.1.1
[*HUAWEI-ospfv3-1] quit
[*HUAWEI] interface vlanif 100
[*HUAWEI-Vlanif100] ipv6 enable
[*HUAWEI-Vlanif100] ospfv3 suppress-flapping peer disable
Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166501

Views: 49885

Downloads: 336

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next