No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
suppress-flapping peer disable (OSPFv3)

suppress-flapping peer disable (OSPFv3)


The suppress-flapping peer disable command disables OSPFv3 neighbor relationship flapping suppression globally.

The undo suppress-flapping peer disable command enables OSPFv3 neighbor relationship flapping suppression globally.

By default, OSPFv3 neighbor relationship flapping suppression is enabled globally.


suppress-flapping peer disable

undo suppress-flapping peer disable




OSPFv3 view

Default Level

2: Configuration level

Usage Guidelines

If an interface carrying OSPFv3 services alternates between Up and Down, OSPFv3 neighbor relationship flapping occurs on the interface. During the flapping, OSPFv3 frequently sends Hello packets to reestablish the neighbor relationship, synchronizes LSDBs, and recalculates routes. In this process, a large number of packets are exchanged, adversely affecting neighbor relationship stability, OSPFv3 services, and other OSPFv3-dependent services, such as LDP and BGP. OSPFv3 neighbor relationship flapping suppression can address this problem by delaying OSPFv3 neighbor relationship reestablishment or preventing service traffic from passing through flapping links.

By default, OSPFv3 neighbor relationship flapping suppression is enabled globally. To disable this function globally, run the suppress-flapping peer disable command.


# Disable neighbor relationship flapping suppression globally.

<HUAWEI> system-view
[~HUAWEI] ospfv3 1
[*HUAWEI-ospfv3-1] suppress-flapping peer disable
Updated: 2019-03-21

Document ID: EDOC1000166501

Views: 93531

Downloads: 407

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next