No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
display ospfv3 troubleshooting

display ospfv3 troubleshooting


The display ospfv3 troubleshooting command displays diagnostic information about OSPFv3 neighbor disconnections.


display ospfv3 troubleshooting




All views

Default Level

1: Monitoring level

Usage Guidelines

To check diagnostic information about OSPFv3 neighbor disconnections, run the display ospfv3 troubleshooting command. A maximum of five OSPFv3 neighbor disconnections can be displayed in the command output.


# Display diagnostic information about OSPFv3 neighbor disconnections.

<HUAWEI> display ospfv3 troubleshooting
Total counts: 2
Sequence   Time                      Event Description                          
 1         2015-11-25 09:29:42       The OSPF 1 peer went Down because o
                                     f mismatched Hello timers. Please check the
                                      OSPF Hello timer configuration.(Interface 
                                     = 10GE1/0/1, PingResult = 5 packets suc
                                     cess, 0 packets timeout)                   
 2         2015-11-25 09:27:18       The OSPF 1 peer went Down because 1
                                     -way Hello packets were received. Please ch
                                     eck the status of neighbor interface.(Inter
                                     face = 10GE1/0/1)                      
Table 9-92  Description of the display ospfv3 troubleshooting command output



Total counts

The count of OSPFv3 neighbor disconnections


Sequence number


Time when the OSPFv3 neighbor disconnection occurred

Event Description

Description of the OSPFv3 neighbor disconnection event

Updated: 2019-03-21

Document ID: EDOC1000166501

Views: 70269

Downloads: 374

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next