No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Command Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
bandwidth-reference (OSPFv3)

bandwidth-reference (OSPFv3)

Function

The bandwidth-reference command sets the bandwidth reference value used to calculate the link cost.

The undo bandwidth-reference command restores the default setting.

By default, the bandwidth reference value of the link cost is 100 Mbit/s. That is, the link cost is 100000000/bandwidth.

Format

bandwidth-reference value

undo bandwidth-reference

Parameters

Parameter Description Value
value Specifies the bandwidth reference value used to calculate the link cost. It is an integer ranging from 1 to 2147483648, in Mbit/s. The default value is 100 Mbit/s.

Views

OSPFv3 view

Default Level

2: Configuration level

Usage Guidelines

If the link cost is not set, OSPFv3 calculates the link cost according to the link bandwidth (Cost = Reference Value/Bandwidth). Using the ospfv3 cost command sets the cost of an interface that runs OSPFv3. The priority of the cost set through the ospfv3 cost command is higher than that of the cost set through the bandwidth-reference command.

The bandwidth-reference command has the same function on Eth-Trunk interfaces and physical interfaces. If the command is executed on an Eth-Trunk interface, the bandwidth of the Eth-Trunk interface is the total bandwidth of all its member interfaces.

Example

# Set the bandwidth reference value of the link cost to 1000.

<HUAWEI> system-view
[~HUAWEI] ospfv3 1
[*HUAWEI-ospfv3-1] bandwidth-reference 1000
Related Topics
Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166501

Views: 50269

Downloads: 337

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next