No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
maxage-lsa route-calculate-delay (OSPFv3)

maxage-lsa route-calculate-delay (OSPFv3)


The maxage-lsa route-calculate-delay command configures a route calculation delay that is triggered when the device receives a MaxAge Router LSA.

The undo maxage-lsa route-calculate-delay command restores the default configuration.

By default, the delay is 20s.


maxage-lsa route-calculate-delay delay-interval

undo maxage-lsa route-calculate-delay


Parameter Description Value
delay-interval Specifies a route calculation delay that is triggered when the device receives a MaxAge Router LSA. The value is an integer ranging from 0 to 65535, in seconds. If the value is set to 0, route calculation is not delayed when the device receives a MaxAge Router LSA.


OSPFv3 view

Default Level

2: Configuration level

Usage Guidelines

Frequent OSPFv3 LSA flapping may lead to route flapping, adversely affecting services. To address this problem, run the maxage-lsa route-calculate-delay command to configure the device to delay route calculation when it receives a MaxAge Router LSA, which suppresses the frequent OSPFv3 LSA flapping that may occur.


# Configure the device to delay route calculation for 200s when the device receives a MaxAge Router LSA.

<HUAWEI> system-view
[~HUAWEI] ospfv3 100
[~HUAWEI-ospfv3-100] maxage-lsa route-calculate-delay 200
Updated: 2019-03-21

Document ID: EDOC1000166501

Views: 87896

Downloads: 400

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next