No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Command Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ingress-lsp trigger

ingress-lsp trigger

Function

The ingress-lsp trigger command specifies a routing policy to control the creation of ingress LSPs based on labeled BGP IPv4 routes.

The undo ingress-lsp trigger command restores the default setting.

By default, ingress LSPs are created based on all received BGP labeled routes.

NOTE:

Only CE8860EI, CE8850EI, CE7855EI, CE7850EI, CE6870EI, CE6860EI, CE6856HI, CE6855HI, CE6851HI, CE6850HI, and CE6850U-HI support this command.

Format

ingress-lsp trigger route-policy route-policy-name

undo ingress-lsp trigger

Parameters

Parameter Description Value
route-policy route-policy-name

Specifies the name of a routing policy to be used to create ingress LSPs based on BGP labeled routes.

The name is a string of 1 to 200 case-sensitive characters, with spaces not supported. When double quotation marks are used around the string, spaces are allowed in the string.

Views

BGP view, BGP-IPv4 unicast address family view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

In a MAN where the hybrid access mode is used, a large number of BGP labeled routes are used to establish end-to-end LSPs. On certain intermediate nodes where VPN services do not need to be supported, excessive ingress LSPs are created, causing the waste of network resources. In this case, you can run the ingress-lsp trigger command to create ingress LSPs based on a routing policy to save network resources.

Configuration Impact

If the ingress-lsp trigger command is run more than once, the latest configuration overrides the previous ones.

Follow-up Procedure

If the routing policy specified in the ingress-lsp trigger command does not exist, you need to configure the routing policy by using the route-policy command.

Example

# Specify a routing policy named test-policy to control the creation of ingress LSPs based on labeled IPv4 routes.

<HUAWEI> system-view
[HUAWEI] bgp 100
[HUAWEI-bgp] ipv4-family unicast
[HUAWEI-bgp-af-ipv4] ingress-lsp trigger route-policy test-policy
Related Topics
Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166501

Views: 50544

Downloads: 337

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next