No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Command Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ospfv3 timer poll

ospfv3 timer poll

Function

The ospfv3 timer poll command sets the polling interval for sending Hello packets on NBMA network.

The undo ospfv3 timer poll command restores the default polling interval.

By default, the polling interval for sending Hello packets on NBMA network is 120 seconds.

Format

ospfv3 timer poll interval [ instance instance-id ]

undo ospfv3 timer poll [ interval ] [ instance instance-id ]

Parameters

Parameter Description Value
interval Specifies the polling interval of Hello packets. The value is an integer ranging from 1 to 65535, in seconds.
instance instance-id Specifies the instance ID of the interface. The value is an integer ranging from 0 to 255. The default value is 0.

Views

Interface view

Default Level

2: Configuration level

Usage Guidelines

On the NBMA network, if a neighbor is invalid, you can configure switchs to send Hello packet based on the polling interval that is set by the ospfv3 timer poll command. The polling interval should be at least 4 times that of the Hello interval.

OSPFv3 does not support the configuration on a null interface.

Before running this command on an interface, run the ospfv3 area command on the interface to enable OSPFv3.

Example

# Set the polling interval for sending Hello packets on the Vlanif10 to 130 seconds.

<HUAWEI> system-view
[~HUAWEI] ospfv3
[*HUAWEI-ospfv3-1] router-id 10.1.1.1
[*HUAWEI-ospfv3-1] quit
[*HUAWEI] interface vlanif 10
[*HUAWEI-Vlanif10] ipv6 enable
[*HUAWEI-Vlanif10] ospfv3 1 area 1
[*HUAWEI-Vlanif10] ospfv3 timer poll 130

# Set the polling interval for sending Hello packets on the 10GE1/0/1 to 130 seconds.

<HUAWEI> system-view
[~HUAWEI] ospfv3
[*HUAWEI-ospfv3-1] router-id 10.1.1.1
[*HUAWEI-ospfv3-1] quit
[*HUAWEI] interface 10ge 1/0/1
[*HUAWEI-10GE1/0/1] undo portswitch
[*HUAWEI-10GE1/0/1] ipv6 enable
[*HUAWEI-10GE1/0/1] ospfv3 1 area 1
[*HUAWEI-10GE1/0/1] ospfv3 timer poll 130
Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166501

Views: 52055

Downloads: 339

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next