No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
tunnel select-seq

tunnel select-seq


The tunnel select-seq command configures the sequence in which different types of tunnels are selected and the number of tunnels participating in load balancing.

The undo tunnel select-seq command restores the default setting.

By default, only LSPs are selected and no load balancing is performed.


CE6850EI, CE6810EI. and CE6810LI series does not support this command.


tunnel select-seq lsp load-balance-number load-balance-number

undo tunnel select-seq


Parameter Description Value
lsp Specifies the sequence of conventional LSPs. The earlier it is listed, the higher the priority. -
load-balance-number load-balance-number Specifies the number of tunnels taking part in load balancing.

The value is an integer that ranges from 1 to 32.


Tunnel policy view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

By default, a VPN instance uses LSPs for service transmission on the backbone network. To configure load balancing for service transmission of the VPN instance, you need to apply a tunnel policy to the VPN instance.

After the tunnel select-seq command is executed, the system selects tunnels for applications according to the tunnel priority sequence configured in the tunnel policy.


After the tunnel select-seq command is executed, apply the configured tunnel policy to the VPN instance so that the VPN instance can select tunnels based on the tunnel policy and have its services load-balanced across tunnels.


# Configure a tunnel policy that only LSPs can be used and no load balancing is performed.

<HUAWEI> system-view
[~HUAWEI] tunnel-policy l2
[*HUAWEI-tunnel-policy-l2] tunnel select-seq lsp load-balance-number 1
Updated: 2019-03-21

Document ID: EDOC1000166501

Views: 88322

Downloads: 405

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next