No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Command Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ospfv3 frr block

ospfv3 frr block

Function

The ospfv3 frr block command blocks FRR on a specified OSPFv3 interface.

The undo ospfv3 frr block command restores the default configuration.

By default, FRR is not blocked on an interface.

Format

ospfv3 frr block [ instance instance-id ]

undo ospfv3 frr block [ instance instance-id ]

Parameters

Parameter Description Value
instance instance-id Specifies the instance ID of the interface. The value is an integer ranging from 0 to 255.

Views

Interface view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

To prevent devices that bear important services from becoming nodes on the backup link, you can run the ospfv3 frr block command on the devices. In this manner, services on the devices are not affected when FRR calculation is performed.

Prerequisites

OSPFv3 has been enabled on the interface using the ospfv3 area command.

Precautions

Before configuring OSPFv3 IP FRR, run the ospfv3 frr block command to block FRR on the specified interface. In this manner, the link connected to the interface is not calculated as a backup link during FRR calculation.

Example

# Block OSPFv3 IP FRR on Vlanfi10.

<HUAWEI> system-view
[~HUAWEI] ospfv3
[*HUAWEI-ospfv3-1] router-id 10.1.1.1
[*HUAWEI-ospfv3-1] quit
[*HUAWEI] interface vlanif 10
[*HUAWEI-Vlanif10] ipv6 enable
[*HUAWEI-Vlanif10] ospfv3 1 area 0
[*HUAWEI-Vlanif10] ospfv3 frr block

# Block OSPFv3 IP FRR on 10GE1/0/1.

<HUAWEI> system-view
[~HUAWEI] ospfv3
[*HUAWEI-ospfv3-1] router-id 10.1.1.1
[*HUAWEI-ospfv3-1] quit
[*HUAWEI] interface 10ge 1/0/1
[*HUAWEI-10GE1/0/1] undo portswitch
[*HUAWEI-10GE1/0/1] ipv6 enable
[*HUAWEI-10GE1/0/1] ospfv3 1 area 0
[*HUAWEI-10GE1/0/1] ospfv3 frr block
Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166501

Views: 68910

Downloads: 374

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next