No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
frr (OSPFv3)

frr (OSPFv3)


The frr command creates an OSPFv3 FRR view and enters the OSPFv3 FRR view.

The undo frr command exits from the OSPFv3 FRR view and deletes the OSPFv3 FRR view.

By default, no OSPFv3 FRR view is created.



undo frr




OSPFv3 view

Default Level

2: Configuration level

Usage Guidelines

Usage Scenario

OSPFv3 IP FRR needs to be configured in the OSPFv3 FRR view. To create an OSPFv3 FRR view and enter the OSPFv3 FRR view, run the frr command. To enable OSPFv3 IP FRR, run the loop-free-alternate command in the OSPFv3 FRR view so that a loop-free backup link can be generated.


OSPFv3 has been enabled using the ospfv3 command.


# Create an OSPFv3 FRR view and enter the OSPFv3 FRR view.

<HUAWEI> system-view
[~HUAWEI] ospfv3 1
[*HUAWEI-ospfv3-1] frr
Updated: 2019-03-21

Document ID: EDOC1000166501

Views: 88287

Downloads: 405

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next