No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Command Reference

CloudEngine 8800, 7800, 6800, and 5800 V200R002C50

This document describes all the configuration commands of the device, including the command function, syntax, parameters, views, default level, usage guidelines, examples, and related commands.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ospfv3 trans-delay

ospfv3 trans-delay

Function

The ospfv3 trans-delay command sets the delay for transmitting LSA on an interface instance.

The undo ospfv3 trans-delay command restores the default value.

By default, the delay for transmitting LSA is 1 second.

Format

ospfv3 trans-delay interval [ instance instance-id ]

undo ospfv3 trans-delay [ interval ] [ instance instance-id ]

Parameters

Parameter Description Value
interval Indicates the delay for transmitting LSA on an interface. The value is an integer ranging from 1 to 800, in seconds. By default, it is 1 second.
instance instance-id Specifies the interface instance ID. The value is an integer ranging from 0 to 255. The default value is 0.

Views

Interface view

Default Level

2: Configuration level

Usage Guidelines

The LSA in the LSDB of the local switch ages with time. The aging of the LSA increases by 1 per second, but the aging of the LSA does not change in the transmission process. Therefore, it is necessary to add the delay to the aging time of the LSA before the LSA is sent.

Before running this command on an interface, run the ospfv3 area command on the interface to enable OSPFv3.

Example

# Set the delay for transmitting LSA on VLANIF 10 to 3 seconds.

<HUAWEI> system-view
[~HUAWEI] ospfv3
[*HUAWEI-ospfv3-1] router-id 10.1.1.1
[*HUAWEI-ospfv3-1] quit
[*HUAWEI] interface vlanif 10
[*HUAWEI-Vlanif10] ipv6 enable
[*HUAWEI-Vlanif10] ospfv3 1 area 1
[*HUAWEI-Vlanif10] ospfv3 trans-delay 3

# Set the delay for transmitting LSA on 10GE1/0/1 to 3 seconds.

<HUAWEI> system-view
[~HUAWEI] ospfv3
[*HUAWEI-ospfv3-1] router-id 10.1.1.1
[*HUAWEI-ospfv3-1] quit
[*HUAWEI] interface 10ge 1/0/1
[*HUAWEI-10GE1/0/1] undo portswitch
[*HUAWEI-10GE1/0/1] ipv6 enable
[*HUAWEI-10GE1/0/1] ospfv3 1 area 1
[*HUAWEI-10GE1/0/1] ospfv3 trans-delay 3
Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166501

Views: 50858

Downloads: 337

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next