No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an ECMP Load Balancing Mode for PPPoE Packets

Configuring an ECMP Load Balancing Mode for PPPoE Packets

Context

By default, CE12800 process received PPPoE packets as common Ethernet packets. Figure 1-7 shows the format of PPPoE packets. The switch cannot identify the 5-tuple information in PPPoE packets and performs the hash algorithm based on the outer Ethernet frame of common Layer 2 packets by default. There are fewer variable fields of Layer 2 Ethernet frames of PPPoE packets and only source MAC addresses of packets from different users are different, so packets are often unevenly load balanced on an ECMP. To improve load balancing, use inner information of PPPoE packets for load balancing.

Figure 1-7 Format of PPPoE packets
NOTE:

The CE12800E can identify PPPoE packets and load balance the PPPoE packets without configuring ECMP load balancing.

Procedure

  • Configure a load balancing mode for PPPoE packets.
    1. Run system-view

      The system view is displayed.

    2. Run load-balance ecmp pppoe { session-id | l4-src-port { ppp-address-compression | ppp-protocol-compression | both | none } }

      A load balancing mode is configured for PPPoE packets.

      By default, PPPoE packets are load balanced based on src-mac, dst-mac, and vlan.

      You can also specify session-id and l4-src-port to configure a load balancing mode for PPPoE packets based on the session ID and transport-layer source interface of the packets.

      NOTE:

      Among all VSs in port mode, only the Admin-VS supports the load balancing mode configuration of PPPoE packets. All VSs in group mode can have a load balancing mode configured for PPPoE packets.

      The CE12800E does not support this command.

    3. Run commit

      The configuration is committed.

Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 276595

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next