No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Extended Community Filter

Configuring an Extended Community Filter


You can use an extended community filter when using the route target (RT) attribute to filter routes in a VPN scenario.


  1. Run system-view

    The system view is displayed.

  2. Run ip extcommunity-filter { basic-extcomm-filter-num | basic basic-extcomm-filter-name } [ index index-number ] { deny | permit } { rt { as-number:nn | 4as-number:nn | ipv4-address:nn } } &<1-16>ip extcommunity-filter { advanced-extcomm-filter-num | advanced advanced-extcomm-filter-name } [ index index-number ] { deny | permit } regular-expression


    An extended community filter is configured.

  3. Run ip extcommunity-list soo basic basic-extcomm-filter-name [ index index-number ] { permit | deny } { site-of-origin } &<1-16>ip extcommunity-list soo advance advanced-extcomm-filter-name [ index index-number ] { permit | deny } regular-expression


    An SoO extended community attribute is configured.

  4. Run commit

    The configuration is committed.

Verifying the Configuration

Run the display ip extcommunity-filter [ basic-extcomm-filter-num | advanced-extcomm-filter-num | extcomm-filter-name ] command to check information about the configured extended community filter.

Run the display ip extcommunity-list soo [ extcomm-filter-name ] command to check information about the configured SoO extended community attribute.

Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 275237

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next