No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).


As networks develop, the demand for data, audio, and video services is growing, which imposes increasing requirements on IP network reliability. If an AMB/SMB switchover is performed on a device due to a maintenance operation or a single point of failure, routes may fail to converge, which may result in traffic loss or even a network breakdown. Non-stop routing (NSR) can address this problem and ensure uninterrupted forwarding of key services.

With Routing Information Protocol next generation (IS-IS) NSR, IS-IS real-time data is synchronized between the AMB and SMB. After an AMB/SMB switchover is performed on a device, the SMB takes over services from the AMB, and neighbors are unaware of the local fault. After the switchover, the new AMB recovers IS-IS immediately based on the synchronized IS-IS real-time data. Therefore, neighbors are unaware of the switchover as well. IS-IS NSR requires synchronization of the following data:

  • All configuration data, such as information about neighbors, timer parameters, and process configurations.

  • Dynamic data, such as the interface parameters and state, and information about neighbors and the link state database (LSDB).


NSR is enabled on the device by default and does not need to be configured.

Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 274085

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next