No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Unicast Routing

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring BFD for OSPFv3

Configuring BFD for OSPFv3


After enabling BFD for OSPFv3, you need to configure BFD parameters in the OSPFv3 process.


  1. Run system-view

    The system view is displayed.

  2. Run ospfv3 process-id

    The OSPFv3 view is displayed.

  3. Run bfd all-interfaces { min-receive-interval receive-interval | min-transmit-interval transmit-interval | detect-multiplier multiplier-value | frr-binding } *

    OSPFv3 BFD parameters are configured.

    By default, BFD parameters are not configured in an OSPFv3 process.

  4. Run commit

    The configuration is committed.

Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 276232

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next