No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

CloudEngine 12800 and 12800E V200R002C50

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, IPv4 IS-IS, IPv6 IS-IS, BGP, Routing Policy, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
RIP NSR

RIP NSR

The device with a distributed architecture supports RIP Non-stop Routing (NSR). RIP backs up all route data from the Active Main Board (AMB) to the Standby Main Board (SMB). Whenever the AMB fails, the SMB becomes active and takes over the AMB. RIP, therefore, can keep the normal operation of services. RIP NSR ensures that real-time data is highly synchronized between the AMB and SMB. Therefore, during the AMB/SMB switchover, the neighbor will not detect the fault on the local device.

NOTE:

NSR is enabled on the device by default and does not need to be configured.

Translation
Download
Updated: 2019-03-21

Document ID: EDOC1000166601

Views: 274508

Downloads: 161

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next